thingiverse.com

For use only on private property you have a legal right to access.

Hhhnnnnggggg I gotta print this.

3D printable. To my knowledge, there isn’t another MIDI breakout for Disting that has both 5 pin MIDI DIN and TRS sockets.

På arbejde har jeg adgang til en Ultimaker S3. Den bliver brugt for lidt, og jeg søger inspiration… Forleden faldt jeg så over en Duplo-Brio-adapter på Thingiverse, jeg vil printe til min datter.

The folks in 3d printing helped me out greatly with this, and I was able to mash this together today. I haven’t printed or tested it yet, but it’s designed to be used with the quad mag ring. I’m going to use some very thin and strong 3m adhesive tape I have to ensure it is secure to the phone, and use for a quadlock mount on the bike if it actually works.

I’ve made vactrols in various ways in the past - black electrical tape, heat shrink, other 3D printed enclosures. This is my latest attempt, to use with an NLC Dispersion Delay build (the design is directly inspired by the vactrols seen in photos in the NLC build docs). I like to sand off the end of the LED so it’s flat and superglue it to the LDR, but I’m not sure this is really necessary.

A Ugrinsky vertical axis wind turbine blade.